Part # 4517125 (09/03)
Page 14
CLEANING AND MAINTENANCE continued
7. Remove the release sheet locking clips and bars.
8. Scrape only the lower grill surface with a grill
scraper, and squeegee any residue into the grease
troughs with a grill squeegee.
Caution: Do not scrape or otherwise scratch the
upper platens. The use of metal scrapers, abrasive
pads, or wire brushes will permanently damage
the surface of the upper platens.
9. Open one packet of high-temperature grill cleaner,
(several cleaners may be available on the market),
and empty the contents into a suitable container.
(One packet will clean one grill.)
10. Firmly attach a no-scratch pad to a pad holder.
11. Dip the no-scratch pad into the grill cleaner, and
spread a light coating of grill cleaner over the entire
platen surface, back, front, and side edges of both
upper platens. DO NOT SCRUB.
12. After applying the grill cleaner, lightly scrub the
platen surfaces, BACK, FRONT AND SIDE
EDGES with the no-scratch pad until all the soil
has been liquefied by the grill cleaner. For stubborn
soils, apply additional grill cleaner and lightly
scrub. DO NOT RINSE THE PLATENS AT
THIS TIME.
13. Starting at the back of the lower grill, spread a light
coating of grill cleaner over the entire surface. DO
NOT SCRUB.
14. After applying the grill cleaner, lightly scrub the
grill surface with the No-Scratch Pad until all the
soil has been liquefied.
15. Rinse the upper platens with a dripping wet cloth.
16. Carefully pour small quantities of lukewarm
water onto the grill while brushing the surface,
backsplash, and bullnose with a pot brush or
equivalent high-temperature brush. Continue until
the water no longer boils away and the grill remains
wet. Squeegee dry.
Caution: Ice, cold water, or large quantities of water
must never be applied to the grill plate or upper platen.
Severe damage to the grill will occur!
17. Clean the release sheets as follows:
A) Place the sheets on the lower grill. Scrub both
sides of the sheets with the same no-scratch
pad used on the grill.
B) Rinse both sides of the sheets with a clean, wet
cloth.
18. Rinse the lower grill by flooding the surface twice
with lukewarm water. Squeegee after each rinse.
19. Wipe the lower grill surface, backsplash, bullnose,
and hood with a clean, damp cloth.
20. When cleaning is completed, you may turn the
“MASTER POWER” (rocker) switch off.
AFTER CLEANING,
apply a thin coat of fresh
shortening to the lower grill surface only. Wipe
down the surrounding areas. Empty, wash, rinse,
and replace the grease troughs.
Platen Zeroing:
Turn Master power switch “ON”, wait for controllers
to display “OFF”.
1. Press and hold for three, (3) seconds. “ENTER
CODE” will be displayed.
2. Using the Gap Setting buttons,
enter the code, (1251). “ENTER CODE **** ” will
be displayed.
3. Press
to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS”
will be displayed.
4. Press
two, (2) times in succession to display
“PROGRAMMING MODE SYSTEM SETUP.”
5. Press six, (6) times. “PLATEN SET +/- XX” will
be displayed. (XX=numbers that will vary from
grill to grill.)
