Part # 4517125 (09/03)
Page 8
GRILL CONTROLS
Master Power Switch:
Controls power to the grill and must be turned “ON”
to start operation. The controller display will be active
when the switch is “ON”.
Indicator Lights:
There are two, (2), indicator lights, indicating the
temperature status of each control’s heat zones; one,
(1), on the upper platen, (top light), and one, (1), on
the grill surface. Each light can display three, (3),
different colors, indicating temperature status for the
corresponding zone.
Red:
The zone is too hot, (more than 79°F/45°C over
the set temperature), or heat zone failure.
Amber:
The zone is calling for heat.
Green:
The zone is at or above the set temperature.
Display:
The controller display will contain information relevant
to each operation in both cook and program modes.
Gap Setting Buttons (1-5):
For two-sided recipes, the desired gap button is pressed
before the cook cycle begins to set the gap. Hold buttons
1-5 to apply gap settings 6-10. The chosen gap button
and its value will be displayed. Until a different menu
item is selected, (or the current item is changed and then
returned to), the Gap Button only needs to be pressed
before the initial cook.
Gap Button:
When in programming mode, press the Gap Button to
set the values for Gap Buttons 1-10. Press Enter to accept
the changes. After going through all ten, you will return
to Programming Mode.
GAP
SETTING
BUTTONS
GAP
BUTTON
DISPLAY
READY
INDICATORS
WHEN PUSHED SIMULTANEOUSLY:
"START COOK TIME COUNTDOWN" (flat grill cooking)
OR "LOWER PLATEN" (two-sided cooking)
POWER
BUTTON
MASTER
POWER
SWITCH
ON
OFF
ENTER
BUTTON
PROGRAM
BUTTON
DOWN ARROW
BUTTON
TEMPERATURE
BUTTON
UP ARROW
BUTTON
CANCEL/
RAISE PLATEN
BUTTON
