GMA 1347D Installation Manual
Page 2-1
190-00303-21
Revision C
2 INSTALLATION
OVERVIEW
2.1 Introduction
This section provides hardware equipment information for installing the GMA 1347D Audio Panel,
related hardware and suggestions relating to the marker beacon antenna. Installation of the GMA 1347D
should follow the aircraft TC or STC requirements. Cabling is fabricated by the installing agency to fit
each particular aircraft. The guidance of FAA advisory circulars AC 43.13-1B and AC 43.13-2B, where
applicable, may be found useful for making retro-fit installations that comply with FAA regulations.
Refer to the G1000 System Installation Manual, Garmin part number 190-00303-00 for further details on
the mechanical aspects of the G1000 system.
2.2 Installation
Materials
The GMA 1347D is available only as a single unit under the following part number:
NOTE
All units are black, unless otherwise noted.
Item Catalog
P/N
GMA 1347D Unit Only, (011-01257-00)
010-00465-00
GMA 1347D Cabin Unit Only, (011-01257-20)
010-00465-20
2.2.1 Equipment
Available
Each of the following accessories are provided separately for the GMA 1347D:
Item Garmin
P/N
Sub Assy, Connector Kit, SB, GMA 1347
011-00813-01
SMP, Install Rack, GMA 1347
115-00427-00
Sub Assy, Bracket Kit, GMA 1347
011-01001-00
Sub Assy, Backplate, GMA 1347
011-00812-00
Sub Assy, Nut Plate Kit, GMA 1347
011-01019-00
Garmin Marker Beacon Antenna Kit**
010-10175-00
**
Note:
A marker beacon antenna approved to TSO C35d that has been installed to meet the
requirements of this manual may be approved for use with the GMA 1347D.
2.2.2 Additional Equipment Required
•
Marker Beacon Coupler
•
Antenna sealant (use manufacturer’s instructions, install according to FAA AC 43.13-2B).
•
Cables: The installer will fabricate and supply all system cables. Interconnect wiring
diagrams are detailed in Appendix B.
•
Hardware: #6-32 x 100
°
Flat Head Screw (6 ea.) and #6-32 Self-Locking Nut (6 ea.). Screws
and Nutplates supplied in nutplate kit 011-01019-00.
•
Stereo headphone jacks (up to 5), microphone jacks (up to 5), 3.5mm stereo jacks (up to 2),
and insulating washers for all.
