37
4. Select the serial port to which the
15xH/15xL is connected. Select
Auto
to have the program automatically
determine the baud rate, or select
Manual
to manually select the baud
rate of the GPS 15xH/15xL. Click
OK
when done.
5. Click Connect, or select
Comm
>
Connect
to connect to the GPS
15xH/15xL.
6. To view the current programming of the
GPS 15xH/15xL, select
Config > Get
Configuration from GPS
(or press the
F8 key). The current programming of
the GPS 15xH/15xL is displayed in the window, as shown on the previous page.
7. Open the Sensor Configuration
Window by pressing the F6 key or
selecting
Config > Sensor
Configuration.
8. Place a check mark in the box next to
Garmin Binary Output to change the
GPS 15xH/15xL to Garmin Mode. The
unit will keep this change in the
programming until you change it again
in the software.
Note
: Selecting
Config
>
Switch to
Garmin Mode
(or pressing the F11
key) only changes the unit to work in
Garmin Mode until power is cycled
through the unit again. For a more
permanent change, refer to step 8
above.
9. Click
OK
.
10. When you are ready to upload the
changes into the GPS 15xH/15xL,
select
Config > Send Configuration
to GPS
(or press the F9 key). The new
configuration is then loaded into the GPS 15xH/15xL.
11. You may disconnect and close the software when finished. The software configuration can
also be saved for future reference.
Refer to
Appendix F: Sensor Configuration Software
for complete information about downloading
the Sensor Configuration Software application.