Fishfinder 350C Owner’s Manual
9
This is the temperature offset. Enter this value as a positive number if the
sensor connected to the fishfinder measures the water temperature as being
colder than it actually is. Enter this value as a negative number if the sensor
connected to the fishfinder measures the water temperature as being warmer
than it actually is.
4
Select
MENU
>
Setup
>
Calibration
>
Temperature Offset
.
5
Use and to select positive (+) or negative (-), based on the value
calculated in step 3.
6
Enter the value of the alarm setting.
7
Select
ENTER
.
8
Check the temperature offset value to ensure you have entered the correct
value.
Calibrating the Water Speed Sensor
1
Select
MENU
>
Setup
>
Calibration
>
Calibrate Water Speed
.
2
Follow the on-screen instructions.
NOTE:
Enter the top speed as measured by an external source, such as a GPS. Do
not enter the water speed value shown on the calibrate water speed page.
Restoring the Original Factory Settings
NOTE:
This procedure deletes all settings information you have entered.
Select
MENU
>
Setup
>
System
>
System Information
>
Factory Settings
>
Yes
.
Appendix
Specifications
Specification
Measurement
Temperature Range
From 5°F to 131°F (from -15°C to 55°C)
Power Source Voltage Range
8–28 Vdc
Rated Current
1 A
Fuse
AGC/3AG - 3.0 A
Freshwater Depth*
1500 ft. (457 m)
Saltwater Depth*
600 ft. (183 m)
* Depth capacity is dependent on water salinity, bottom type, and other water
conditions.
The included transducer has beam angles of 15 and 45 degrees at 3 dB. However,
when this transducer is used with the fishfinder device, it can detect the smallest
signals up to 60 and 120 degrees. Shallow and deep water performance is
maximized when this transducer and this fishfinder are used together because the
fishfinder shows more fish in shallower water, and it shows more details in deeper
water, such as structures and water bottom contours.
Cleaning the Outer Casing
NOTICE
Avoid chemical cleaners and solvents that can damage plastic components.
1
Clean the outer casing (not the screen) of the device using a cloth dampened
with a mild detergent solution.
2
Wipe the device dry.
190-01440-00_0B.indd 9
3/21/2012 1:00:09 PM
