P/N 11934-S38
5 of 10
Cirrus Design
Section 9
SR20
Supplements
Section 4 - Normal Procedures
Refer to the Systems Description Section of this supplement for
integration differences when single and dual units are installed.
Normal operating procedures are outlined in the Garmin 400W-Series
GPS Navigator Pilot's Guide and Reference, P/N 190-00356-00,
Revision A or later.
Activate Navigator
1.
Battery Master Switch................................................................ON
2.
Avionics Power Switch ...............................................................ON
3.
Navigator COM/ Power Switch....................................... Rotate ON
The Navigator will display a welcome page while the self-test is in
progress. When the self test is successfully completed, the
Navigator asks for NavData database confirmation, acquires
position, and then displays the acquired position on the Navigators
display and on the MFD.
• Note •
The Navigator is not coupled to an air and fuel data computer.
Manual fuel-on-board and fuel flow entries must be made in
order to use the fuel planning function of the AUX pages.
The GPS Navigator utilizes altitude information from the
altitude encoders altitude digitizer to enhance altitude
information.
Deactivate Navigator
1.
Navigator COM/ Power Switch............................Rotate CCW OFF
Section 5 - Performance
No change from basic Handbook.
Section 6 - Weight & Balance
No change from basic Handbook.
Revision 02: 10-29-13
