G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Page 7-7
190-00716-01
Revision 1
VHF COM Interference Test
This test must be conducted outside. Use of a GPS repeater inside a hangar may result in a failed test.
This procedure assumes that the system is currently set to 25 kHz COM channel spacing. Once the signal
acquisition test has been completed successfully, perform the following steps:
1.
On the MFD, monitor GPS signal strength bars on the AUX – GPS STATUS page.
2.
On the PFD, ensure that the CDI is set to GPS. If it is not, press the ‘CDI’ softkey until GPS ENR is
displayed.
3.
Verify that the GPS “INTEG” flag is out of view.
4.
Select 121.150 MHz on the No. 1 COM transceiver.
5.
Transmit for a period of 35 seconds while monitoring GPS 1 signal strength levels.
6.
During the transmit period, verify that the GPS “INTEG” flag does not come into view on the PFD
and verify that GPS 1 does not lose a 3-D navigation solution on the MFD.
7.
Repeat steps 5 and 6 and re-transmit while monitoring GPS 2 signal levels on the MFD.
8.
Repeat steps 4 through 7 for each of the following frequencies:
•
121.175 MHz
•
121.200 MHz
•
131.250 MHz
•
131.275 MHz
•
131.300 MHz
9.
Repeat steps 4 through 8 for the No. 2 COM transceiver (GIA2).
10.
On the MFD, select the AUX – SYSTEM SETUP page.
11.
Under the COM CONFIG field, change the COM channel spacing from 25 kHz to 8.33 kHz.
12.
Go back to the AUX – GPS STATUS page.
13.
Select 121.185 MHz on the No. 1 COM transceiver.
14.
Transmit for a period of 35 seconds while monitoring GPS 1 signal strength levels.
15.
During the transmit period, verify that the GPS “INTEG” flag does not come into view on the PFD
and verify that GPS 1 does not lose a 3-D navigation solution on the MFD.
16.
Repeat steps 14 and 15 and re-transmit while monitoring GPS 2 signal levels on the MFD.
17.
Repeat steps 14 through 16 for each of the following frequencies:
•
121.190 MHz
•
130.285 MHz
•
131.290 Mhz
18.
Repeat steps 14 through 17 for the No. 2 COM transceiver (GIA2).
19.
On the MFD, select the AUX – SYSTEM SETUP page and change the COM channel spacing back
to 25 kHz.
Summary of Contents for Cessna Caravan G1000
Page 2: ...This page intentionally left blank...
Page 89: ......