Page 7-34
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 1
190-00716-01
7.15 Non-Garmin
Traffic
System (TCAS II) Functional Check
1.
Select the
TRAFFIC MAP
page on the MFD.
2.
Verify that the REL, ABS, TFC STBY, TA ONLY, TA/RA, TEST and ALT RNG softkeys are
available on the bottom of the MFD.
NOTE
If the correct softkeys are not displayed, the G1000 has not been properly configured for
the traffic system. Reference section 3.16 “TCAS II Traffic System Option
Configuration” to enable the traffic system.
3.
Verify that
FAIL
is not displayed in the upper left corner of the traffic map.
4.
Verify that
NO DATA
is not displayed in the center of the traffic map over the aircraft symbol.
5.
Press the
TFC STBY
softkey and verify that
STANDBY
is displayed in the upper left corner of the
traffic map.
6.
Press the
TA ONLY
softkey and verify that
TA ONLY
is displayed in the upper left corner of the
traffic map.
7.
Press the
TEST
softkey and verify that the traffic system enters a self-test. Upon successful
completion of the test, verify that “
TCAS SYSTEM TEST OK
” is heard over the cockpit speaker.
8.
Open the TRFC circuit breaker on the copilot circuit breaker panel. On the MFD, verify that
“NO
DATA”
is displayed after several seconds.
9.
Close the TRFC circuit breaker on the copilot circuit breaker panel and verify that
“NO DATA”
is
removed after several seconds.
Summary of Contents for Cessna Caravan G1000
Page 2: ...This page intentionally left blank...
Page 89: ......