__________________________________________________________________________
Page 6-6
G1000 System Maintenance Manual
Rev.A
190-00903-00
6.12 GSM 85(A)
To remove:
1.
Remove the GSA 81 Servo according to Section 6.10.
2.
De-rig the flight control cabling or chain.
3.
Use a socket or open-wrench to loosen and remove the servo attachment bolts.
4.
Carefully remove the servo mount.
To install:
Follow the installation instructions in the respective servo installation drawing. If no other
maintenance is to be performed, reinstall the servo(s).
6.13 GSD 41
To remove:
1.
Loosen the Phillips screw to unlock unit handle.
2.
Pull the GSD lever up towards the top of the unit. This disengages the locking stud with the
dogleg slot.
To install:
1.
Inspect connector(s) for damaged pins.
2.
Gently push unit into the rack to engage the connectors.
3.
Push the GSD 41 lever down towards the bottom of the unit avoiding the use of excessive
force. If lever fails to go down, adjust backplate while engaging unit.
4.
Lock the handle into the GSD 41 body and tighten the Phillips screw.
6.14 GRT 10
To remove:
1.
Loosen the Phillips screw to unlock unit handle.
2.
Pull the GRT lever up towards the top of the unit. This disengages the locking stud with the
dogleg slot.
3.
Slide unit out of rack.
To install:
1.
Inspect connector(s) for damaged pins.
2.
Gently push unit into the rack and engage the connectors.
3.
Push the GRT lever down towards the bottom of the unit avoiding the use of excessive force.
4.
If lever fails to go down, adjust backplate while engaging unit.
5.
Lock the handle into the GRT body and tighten the Phillips screw.
