____________________________________________________________________
Page 7-32
G1000 System Maintenance Manual
Rev. A
190-00903-00
7.1.12
GMC 710 or GMC 715
Original GMC 710 or GMC 715 Reinstalled:
If the removed GMC 710 or GMC 715 is re-installed (same serial number), no software loading
or configuration is required. This does not include units that were returned for repair as their
software and configuration files are deleted during the repair testing process.
New or Repaired GMC 710 or GMC 715 Installed:
If a new or repaired GMC 710 or GMC 715 is installed, load the following files after removing
the Supplemental Database cards from the bottom slots of each display. Note which card was
removed from the MFD so it may be identified later for reinsertion in the MFD when software
and configuration loading is complete. It contains a FliteChart or Chartview database which is
only used by the MFD. Reinstall all the cards after the software and configuration file loads are
complete.
•
GMC Software
•
GMC Configuration
7.1.12.1
GMC 710 or GMC 715 Testing
Perform a basic operation check on the GMC 710.
