______________________________________________________________________________
____________________________________________________________________________
LMM for the Kodiak 100
Page 5-19
190-02102-00 Rev.4
1. To Remove:
a) Remove the GEA 71B.
b) Remove the GEA 71B connector backplate.
c) Remove connector assembly J711 from the backplate.
d) Remove screws, item 7, and cover, item 6, from the backshell, item 5.
e) Unscrew thermocouple from boss on backshell. Extract the thermocouple
pins from the connector.
2. To Replace:
a) Crimp pins, item 2, onto each of the thermocouple wires, item 1. Ensure that
pre-stripped wire length is 1/8" before crimping.
b) Insert newly crimped pins and wires into the appropriate connector housing
location, item 4, as specified by the Kodiak Wiring Diagram.
c) Place thermocouple body, item 1, onto the backshell boss, item 5. Place the
so the wires exit towards the bottom of
the backshell.
d) Place thermocouple body, item 1, onto the backshell boss, item 5. Place the
so the wires exit towards the bottom of
the backshell.
e) Fasten cover, item 6, to backshell using screws, item 7.
f) Make sure the ITT indications are valid on the MFD.
Uncontrolled if Printed
Summary of Contents for Cessna Caravan G1000
Page 2: ...BLANK PAGE Uncontrolled if Printed...
Page 288: ...Uncontrolled if Printed...
