______________________________________________________________________________
____________________________________________________________________________
LMM for the Kodiak 100
Page 6-3
190-02102-00 Rev. 4
6.3 Reloading Procedures
NOTE
If the technician skips the reloading of a replaced LRU, an ‘LRU replace-
ment detected’ message is shown on the GDU in normal mode. This mes-
sage persists until the LRU software reloading procedure is performed. The
‘LRU replacement detected’ message may not be displayed if there are
existing Manifest error or Configuration error messages.
1. Replace the faulty LRU hardware according to the procedures in
.
2. Start the system in configuration mode.
3. Select the LRU Replacement Page.
4. Press the FMS knob. The LRU window is highlighted.
5. Turn the small FMS. A drop down list is displayed showing all of the LRUs
installed in the system.
6. Turn the small FMS knob to select the LRU which was replaced and press
ENT.
7. The Product Window fills with all of the necessary software and configura-
tion for the replaced LRU.
8. Press the Load softkey. Software and configuration begins loading,
including any required options.
9. Press ENT to acknowledge the loading was complete. PASS indicates
loading was successful.
10. Deactivate the cursor.
Uncontrolled if Printed
Summary of Contents for Cessna Caravan G1000
Page 2: ...BLANK PAGE Uncontrolled if Printed...
Page 288: ...Uncontrolled if Printed...