______________________________________________________________________________
____________________________________________________________________________
LMM for the Kodiak 100
Page 7-17
190-02102-00 Rev.4
Figure 7-5. Fixed Wing Aircraft Position Example
With the aircraft stationary, initiate the magnetometer calibration procedure as follows:
1. Enter configuration mode (refer to
as needed).
2. Select the GRS/GMU Calibration page on the PFD. The GRS/GMU Calibration
page is protected and requires a keystroke password to perform the calibration.
Press the following softkeys in sequence: 9, 10, 11, 12.
3. Press the FMS inner knob to highlight GRS1 and press the ENT key.
4. After selecting GRS1, the SELECT PROCEDURE field will begin flashing.
5. Using the FMS small knob, select MAGNETOMETER and press the ENTER key.
If the MAGNETOMETER selection continues to flash, press the ENTER key
again.
6. Follow the checklist items displayed on the PFD and press the ENTER key as
each one is completed or confirmed. When the CALIBRATE field is flashing,
press the ENTER key to begin the procedure.
7. The PFD advises the operator when to turn the aircraft, when to stop, and when
to turn again.
8. The PFD guides the operator to dwell at multiple headings around a complete
circle.
Uncontrolled if Printed
Summary of Contents for Cessna Caravan G1000
Page 2: ...BLANK PAGE Uncontrolled if Printed...
Page 288: ...Uncontrolled if Printed...