190-00820-08 Rev. A
Cirrus Perspective
™
by Garmin – Pilot’s Guide for the SR20/SR22/SR22T
71
FLIGHT INSTRUMENTS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
Changing navigation sources:
1)
Press the
CDI
Softkey to change from GPS to VOR1 or LOC1. The NAV1 standby frequency in the upper left
corner of the MFD is light blue.
2)
Press the
CDI
Softkey again to change from VOR1 or LOC1 to VOR2 or LOC2. The NAV2 standby frequency in
the upper left corner of the MFD is light blue.
3)
Press the
CDI
Softkey a third time to return to GPS.
Figure 2-22 Selecting a Navigation Source
Pressing the
CDI
Softkey Cycles through
Navigation Sources
GPS
Selected
NAV1 Selected for Tuning
LOC1
Selected
NAV2 Selected for Tuning
VOR2
Selected
The system automatically switches from GPS to LOC navigation source and changes the CDI scaling
accordingly when all of the following occur:
• A localizer or ILS approach has been loaded into the active flight plan
• The Final Approach Fix (FAF) is the active leg, the FAF is less than 15 nm away, and the aircraft is moving
toward the FAF
• A valid localizer frequency has been tuned
• The GPS CDI deviation is less than 1.2 times full-scale deflection
GPS steering guidance is still provided after the CDI automatically switches to LOC until LOC capture, up
to the Final Approach Fix (FAF) for an ILS approach, or until GPS information becomes invalid. Activating a
Vector-to-Final (see the Flight Management Section) also causes the CDI to switch to LOC navigation source;
GPS steering guidance is not provided after this switch.
Summary of Contents for Cirrus Perspective SR20
Page 1: ... Cirrus SR20 SR22 SR22T Integrated Avionics System Pilot s Guide ...
Page 2: ......
Page 655: ......