190-00820-11 Rev. A
Pilot’s Guide for the Cirrus SR2x with Cirrus Perspective by Garmin
275
FLIGHT MANAGEMENT
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
APPROACHES
NOTE:
If certain GPS parameters (SBAS, RAIM, etc.) are not available, some published approach procedures
for the desired airport may not be displayed in the list of available approaches.
An Approach Procedure (APPR) can be loaded at any airport that has one available, and provides guidance
for non-precision and precision approaches to airports with published instrument approach procedures. If
an approach is loaded when another approach is already in the flight plan, the new approach replaces the
previous approach, unless the active leg is past the missed approach point. In this case, the second approach
is loaded at the end of the previous approach, and the previous approach is converted to waypoints (no longer
part of an APPR). The approach sequence is defined by selection of an approach and the transition waypoints.
Whenever an approach is selected, the choice to either “Load” or “Load & Activate” is given (“Load &
Activate” is only available for the active flight plan). “Loading” adds the approach to the end of the flight plan
without immediately using it for navigation guidance. This allows continued navigation via the intermediate
waypoints in the original flight plan, but keeps the procedure available for quick activation when needed.
“Activating” also adds the procedure to the end of the flight plan but immediately begins to provide guidance
to the first waypoint in the approach.
When selecting an approach, a “GPS” designation to the right of the approach type indicates the procedure
can be flown using the GPS receiver. Some procedures do not have this designation, meaning the GPS
receiver can be used for supplemental navigation guidance only. If the GPS receiver cannot be used for
primary guidance, the appropriate navigation receiver must be used for the selected approach (e.g., VOR or
ILS). The final course segment of ILS approaches, for example, must be flown by tuning the NAV receiver to
the proper frequency and selecting that NAV receiver on the CDI.
Perspective SBAS GPS allows for flying LNAV, LNAV+V, LNAV/VNAV, LP, LP+V, and LPV approach service
levels according to the published chart. The ‘+V’ designation adds advisory vertical guidance for assistance in
maintaining a constant vertical glidepath similar to an ILS glideslope on approach. This guidance is displayed
on the system PFD in the same location as the ILS glideslope using a magenta diamond. Baro VNAV guidance
is displayed on the system PFD in the same location as the ILS glideslope using a magenta pentagon. The
active approach service level is annunciated on the HSI as shown in the following table: