Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A
223
Annunciations & Alerts
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EAS
Audio and
CNS
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Abnormal
Oper
ation
Annun/Alerts
Appendix
Index
System Message
Comments
COM #2 INOP: SyNTH
–
COM Synthesizer Lock Fault.
COM 2 has a synthesizer lock fault.
COM #2 INOP: VOLT
–
Check COM Voltage.
COM 2 has low voltage.
COM #2 REDUCED TX
POWER
– Reduced COM
transmit power.
COM 2 has a reduced transmission power.
COM1 PTT
– COM1 push-
to-talk key is stuck.
The COM1 external push-to-talk switch is stuck in the enable (or
“pressed”) position. Press the PTT switch again to cycle its operation. If
the problem persists, the system should be serviced.
COM1 RMT XFR
– COM1
remote transfer key is stuck.
The COM1 transfer switch is stuck in the enabled (or “pressed”) position.
Press the transfer switch again to cycle its operation. If the problem
persists, the system should be serviced.
COM2 PTT
– COM2 push-
to-talk key is stuck.
The COM2 external push-to-talk switch is stuck in the enable (or
“pressed”) position. Press the PTT switch again to cycle its operation. If
the problem persists, the system should be serviced.
COM2 RMT XFR
– COM2
remote transfer key is stuck.
The COM2 transfer switch is stuck in the enabled (or “pressed”) position.
Press the transfer switch again to cycle its operation. If the problem
persists, the system should be serviced.
COPILOT PTT STUCK
–
GMA 1 Copilot Push-to-Talk
is Stuck
The GMA 1 external push-to-talk switch is stuck in the enable (or
“pressed”) position. Press the PTT switch again to cycle its operation. If
the problem persists, the system should be serviced.
DATA LOST
– Pilot stored
data was lost. Recheck
settings.
The pilot profile data was lost. System reverts to default pilot profile
and settings. The pilot may reconfigure the MFD & PFDs with preferred
settings, if desired.
DATABASE CHANGE
–
Verify stored airways.
This occurs when a stored flight plan contains an airway that is no longer
consistent with the navigation database. This alert is issued only after a
navigation database update. Verify use of airways in stored flight plans
and reload airways as needed.
DATABASE CHANGE
– Verify user modified
procedures.
This occurs when a stored flight plan contains procedures that have been
manually edited. This alert is issued only after a navigation database
update. Verify the user-modified procedures in stored flight plans are
correct and current.
DATABASES
DOWNLOADING
– See
databases page for more
information.
Databases are downloading to the system. Go to the ‘Database Status’
Screen to monitor status.
