Oregon Series Owner’s Manual
Appendix
Attaching the Carabiner
A carabiner with a clip comes with the
Oregon 300 and 400 series units and is
optional with 200 series units.
To attach the carabiner clip:
1. Position the carabiner clip in the slots
on the mounting spine of the Oregon.
Carabiner clip
Carabiner
Mounting spine
2. Slide the clip up until it locks in place.
To remove the carabiner clip, lift the
bottom of the clip and slide the carabiner
clip off the mounting spine.
Calibrating the
Touchscreen
The Oregon screen does not normally
require calibration. However, if the
buttons do not seem to be responding
properly, use the following process.
To calibrate the touchscreen:
1. While the unit is turned off, press and
hold the
Power
key for
approximately 30 seconds.
2. Follow the instructions on the screen
until “Calibration is complete” is
displayed.
3. Touch
OK
.
Software License
Agreement
BY USING THE OREGON, YOU AGREE
TO BE BOUND BY THE TERMS AND
CONDITIONS OF THE FOLLOWING
SOFTWARE LICENSE AGREEMENT. PLEASE
READ THIS AGREEMENT CAREFULLY.
Garmin grants you a limited license to use
the software embedded in this device (the
“Software”) in binary executable form in the
Summary of Contents for Colorado 400t
Page 1: ...Oregon series owner s manual...
Page 47: ......
