5 Align the tabs on the back of the device with the bike mount notches .
6 Press down slightly and turn the device clockwise until it locks into place.
Installing the Out-Front Mount
NOTE: If you do not have this mount, you can skip this task.
1 Select a secure location to mount the Edge device where it does not interfere with the safe operation of your
bike.
2 Use the hex key to remove the screw from the handlebar connector
.
3 Place the rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm or 26 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
• If the handlebar diameter is 35 mm, do not use a rubber pad.
4 Place the handlebar connector around the rubber pad.
Device Information
69
