37
Appendix C
The eMap uses “pop-up” messages to alert you to unit operating characteristics.
Press the
ENTER
key to acknowledge and return to the page you were viewing.
Approaching Turn
- You are less than one minute away from a turn in your
route.
Arriving at Destination
- You have reached your destination.
Base Map Failed
- The unit’s base map has failed. Return your unit to GARMIN
for service.
Batteries Low
- The batteries in your unit are low and no longer capable of
supporting unit operation. Install new batteries.
Database Error
- There was an error in the unit’s database.
GPS Turned Off (for use indoors)
- The eMap’s GPS receiver has been turned
off to conserve battery power and speed Map Page display drawing.
Lost Satellite Reception
- The unit has lost satellite signals. Try moving to
another location with a clearer view of the sky.
Memory Full
- The unit’s memory is full. To reduce the amount of memory
used, delete unused routes, waypoints or tracks.
No Differential GPS Position
- The beacon receiver is not communicating
with the unit. Refer to the ‘Interface’ setup page of the unit to view the ‘Status’ field.
None Found
- There is no such address, intersection, point of interest, or city
in the map information database. Check spelling or number entry and try again.
RAM Failed
- The eMap has detected a failure in its internal memory. If the
message persists, service is required.
ROM Failed
- The permanent memory has failed and the unit is not operable.
Service is required.
Route Already Exists
- The name you selected has already been assigned.
Choose another name.
Route Memory Full
- No additional route waypoints can be added.
Route Truncated
- A complete uploaded route will not fit into memory. Modify
the route to reduce size.
Route Waypoint Memory Full
- There is no more space for map-based
waypoints.
Track Already Exists
- The name selected has been assigned.
Track Memory Full
- All of the saved track locations are used.
Track Truncated
- A complete uploaded track will not fit into memory. Clear
existing track memory or reduce the amount of new track data.
Transfer Complete
- The eMap has finished uploading or downloading
information to the connected device.
Waypoint Already Exists
- The name you selected has already been assigned.
Choose another name.
Waypoint Memory Full
- All of the waypoints have been assigned.
Messages