190-01700-00
Flight Stream 110/210 TSO Installation Manual
Rev. B
Page 3-1
3 INSTALLATION PROCEDURE
This section provides hardware equipment information for installing the Flight Stream. For interconnects
with interfaced equipment, see appendix B.
3.1 Wiring Harness Installation
Allow adequate space for installation of cables and connectors. All electrical connections are made
through a 15-pin D-sub connector provided by Garmin. Construct the wiring harness according to the
information contained in this and the following sections. Cable lengths will vary depending upon
installation.
1. Strip all wires going to the D-sub connectors 0.17".
2. Insert the wire into the pin and crimp with one of the recommended (or equivalent) crimping tools.
3. Insert the pin into the D-sub connector housing locations as specified by the interconnect drawing
in appendix B.
4. Verify the pin is properly engaged into the connector by gently tugging on the wire.
5. Route and secure the cable run from the Flight Stream to the other units away from sources of
electrical noise.
section 6 defines the electrical characteristics of all input and output signals. Required connectors and
associated hardware are supplied with the connector kit. See appendix B for interconnect wiring diagrams.
3.2 Flight Stream Backshell Assembly and D-sub Connector
3.2.1
Flight Stream Connector Assembly
Table 3-1. Connector and Backshell Assembly
See figure 3-1
Description
Garmin P/N
1
Screw, 4-40x.187, FLHP100, SS/P with Nylon
211-63234-06
2
Cover, Backshell, Jackscrew
115-01079-00
3
Screw, 4-40x.375, PHP, SS/P with Nylon
211-60234-10
4
Clamp, Backshell, Jackscrew
115-01078-00
5
Backshell, Jackscrew, 15 Pin
125-00171-00
6
Conn, HD D-Sub, 15 Pin
330-00626-15