Installing the Remote Control Cradle
You can install the included remote cradle to store the remote when not in use. Mounting hardware for the
cradle is not included.
NOTICE
This remote control is not weatherproof. Failure to install the cradle in a location that is not exposed to the
elements could result in damage to the remote control.
1 Using the cradle as a template, mark the two pilot holes.
2 Remove the cradle from the mounting surface and drill the pilot holes.
NOTICE
Do not drill through the cradle when drilling the pilot holes. This may damage the cradle.
3 Secure the cradle to the mounting surface using two 4 gauge (3 mm) countersunk stainless-steel screws.
Installing the Batteries
You must install AAA alkaline batteries (not included) in the remote control.
1 Slide the battery door to the back of the remote, and pull up to open it.
2 Insert two AAA batteries, observing polarity.
3 Slide the battery door back onto the remote to close it.
Wireless RGB LED Remote Control Instructions
3
