190-00663-00 Rev. A
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT
2-17
FLIGHT INSTRUMENTS
When a bearing pointer is displayed, its associated information window is also displayed. The Bearing
Information windows (Figure 2-25) are displayed to the lower sides of the HSI and show:
• Bearing source (NAV, GPS, ADF)
• Pointer icon (BRG1 = single line, BRG2 = double line)
• Frequency (NAV)
• Station/waypoint identifier (NAV, GPS)
• GPS-derived great circle distance to bearing
source
If the NAV radio is the bearing source and is tuned to an ILS frequency (refer to the Audio Panel and CNS
Section for information on tuning the radios), the bearing pointer is removed from the HSI and the frequency
is replaced with “ILS”. When NAV1 or NAV2 is the selected bearing source, the frequency is replaced by the
station identifier when the station is within range. If GPS is the bearing source, the active waypoint identifier
is displayed in lieu of a frequency.
The bearing pointer is removed from the HSI and “NO DATA” is displayed in the information window if:
• The NAV radio is not receiving the tuned VOR
station
• GPS is the bearing source and an active waypoint
is not selected
Selecting bearing display and changing sources:
1)
Press the
PFD
Softkey.
2)
Press a
BRG
Softkey to display the desired bearing pointer and information window with a NAV source.
3)
Press the
BRG
Softkey again to change the bearing source to GPS.
4)
Press the
BRG
Softkey a third time to change the bearing source to ADF (note: ADF radio installation is
optional).
5)
To remove the bearing pointer and information window, press the
BRG
Softkey again.
DME INFORMATION WINDOW
NOTE:
DME radio installation is optional.
The DME Information Window is displayed above the BRG1 Information Window and shows the DME
label, tuning mode (NAV1, NAV2, or HOLD), frequency, and distance. When a signal is invalid, the distance
is replaced by “–.– – NM”. Refer to the Audio Panel and CNS Section for information on tuning the radios.
Displaying the DME Information Window:
1)
Press the
PFD
Softkey.
2)
Press the
DME
Softkey to display the DME Information Window above the BRG1 Information Window.
3)
To remove the DME Information Window, press the
DME
Softkey again.
Summary of Contents for G1000:Beechcraft Baron 58/G58
Page 1: ...Hawker Beechcraft C90A GT...
