190-00962-02 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA42NG
407
HAZARD AVOIDANCE
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
Figure 6-160 Navigation Map Page Setup Menu
Figure 6-159 Navigation Map Page Menu
Figure 6-161 Navigation Map Page Setup Menu, Traffic Group
TRAFFIC MAP PAGE
The Traffic Map Page is specialized to show surrounding TIS traffic data in relation to the aircraft’s current
position and altitude, without clutter from the basemap. It is the principal page for viewing TIS data. Aircraft
orientation on this map is always heading up unless there is no valid heading. Map range is adjustable with the
RANGE
Knob from 2 to 12 nm, as indicated by the map range rings.
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. Once the aircraft is airborne, TIS switches from Standby to
Operating Mode and the G1000 begins to display traffic information. Refer to the System Status discussion for
more information.
Displaying traffic on the Traffic Map Page:
1)
Turn the large
FMS
Knob to select the Map Page Group.
2)
Turn the small
FMS
Knob to select the Traffic Map Page.
3)
Confirm TIS is in Operating Mode:
Press the
OPERATE
Softkey to begin displaying traffic.
Or
:
a)
Press the
MENU
Key.
b)
Select ‘Operate Mode’ (shown if TIS is in Standby Mode) and press the
ENT
Key.
