Garmin G1000 Pilot’s Guide for the Diamond DA42NG
190-00962-02 Rev. A
460
AUTOMATIC FLIGHT CONTROL SYSTEM
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
INTERCEPTING A VOR RADIAL
During climb-out, the autopilot continues to fly the aircraft in Heading Select Mode. Airway V4 to Salina
VOR (SLN) should now be intercepted. Since the enroute flight plan waypoints correspond to VORs, flight
director Navigation Mode using either VOR or GPS as the navigation source may be used. In this scenario, VOR
Navigation Mode is used for navigation to the first VOR waypoint in the flight plan.
Intercepting a VOR radial:
1)
Arm VOR Navigation Mode:
a)
Tune the VOR frequency.
b)
Press the
CDI
Softkey to set the navigation source to VOR.
c)
Use the
CRS
Knob to set the Selected Course to 255°. Note that at this point, the flight director is still in
Heading Select Mode and the autopilot continues to fly 290°.
d)
Press the
NAV
Key. This arms VOR Navigation Mode and the white ‘VOR’ annunciation appears to the left of
the active lateral mode.
2)
As the aircraft nears the Selected Course, the flight director transitions from Heading Select to VOR Navigation
Mode and the ‘VOR’ annunciation flashes green. The autopilot begins turning to intercept the Selected
Course.
3)
The autopilot continues the turn until the aircraft is established on the Selected Course.
Figure 7-35 Intercepting a VOR Radial
0
3
6
9
12
15
18
21
24
27
30
33
HDG Mode
, V
OR Armed
VO
R NA
V Mode
V 4
Salina
VOR
(SLN)
1
2
3
Hdg
290
o
255
o
