Page B-18
G1000 Nav III Line Maintenance Manual
Rev.L
190-00352-00
f)
CALIBRATION
i.
Press the LOAD softkey.
ii.
Press the ENT key at the START CONFIGURATION UPLOAD prompt.
iii.
Press the ENT key at the CONFIGURATION UPLOAD COMPLETE prompt.
g)
AUDIO
i.
Press the LOAD softkey.
ii.
Press the ENT key at the START CONFIGURATION UPLOAD prompt.
iii.
Press the ENT key at the CONFIGURATION UPLOAD COMPLETE prompt.
iv.
5.
Ensure that all Configuration files are ‘Complete’ in the SUMMARY field as shown:
Optional Configuration
The following configuration options are now available for some G1000 equipped Nav III aircraft:
•
KN63 DME
•
KR87 ADF
•
Artex C406-N ELT
•
KTA870 TAS
•
CO Guardian
•
GDL 90
•
KAP 140
•
GFC 700
Once these optional systems are installed, follow the procedure below to configure the G1000.
NOTE
Ensure that the base airframe configuration option is selected and loaded first after a software
upload, LRU replacement, or optional system installation. The optional system configuration
(detailed below) will be overwritten by the base airframe configuration if the optional system
configuration is completed first.
1.
Insert the proper G1000 Nav III Loader Card into the top card slot of the PFD.
2.
While holding the ENT key on PFD, apply power by closing the PFD circuit breaker.
3.
When the words
appear in the upper left corner of the PFD, release the
ENT key.
4.
Turn the MFD on in the same manner.
Summary of Contents for G1000 NAV III
