G1000 Nav III Line Maintenance Manual
Page 2-67
190-00352-00
Rev.
L
In the Aircraft:
13.
Set the STBY BATT CB to open.
14.
Record the BATT S current (in Amps) from the bottom right corner of the EIS strip. Label this reading as
READING #1 and ensure proper sign (+ or -). If reading is greater the +1 Amp or less the -1 Amp,
Garmin recommends replacing the GEA 71.
15.
Power down PFD1 and MFD1.
A.
AVIONICS Switch (BUS 1 and BUS 2) – Off
B.
MASTER Switch (BAT) – Off
C.
STBY BATT Switch – Off
On the PC:
16.
Insert the SD Card into the card reader.
17.
Run the HSCM.exe program (verify interface resembles Figure 2-27).
Figure 2-27. HSCM Offset Tool User Interface
18.
Choose
Cessna SEP
in the
Select Aircraft
field.
19.
Standby Battery Ammeter
is the only selection available in the
Select Channel
field.
20.
Enter
0.0
in the
Input Offset Error in Amps
field.
This step will reset any previous calibrations to zero
before performing the actual calibration.
21.
Verify the drive letter of the SD card reader is selected in the
Select SD Card Drive Letter
field.
22.
Press the
Create Correcting Config File
button.
23.
Press
OK
to acknowledge the pop-up box.
A non-zero value will be used later in this procedure.
24.
Verify the pop-up box annunciates “Cessna SEP file written to drive” and press
OK
to acknowledge.
25.
Press the
Close
button.
26.
Remove the SD card from the card reader.
In the Aircraft:
27.
Insert the SD card into the upper card slot of the PFD.
28.
Power up MFD1 and PFD1 in Configuration mode:
A. MASTER Switch (BAT) – On
B. AVIONICS Switch (BUS 1 and BUS 2) – On
Summary of Contents for G1000 NAV III
