G1000 Supplemental Maintenance Manual
Page 7-22
Textron Nav III Series
Revision 3
190-02128-04
5. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate
the large FMS knob to highlight
“0X - XXX”
(where 0X is the menu position and XXX is
the airframe type) and press
ENT
key on the PFD.
6. Rotate the small FMS knob to display the drop down menu. Rotate the large FMS knob
to highlight
“Baseline Option – GTX 335 Installation” OR “Baseline Option – GTX
345 Installation, without GTS 800” or “Baseline Option – GTX 345 Installation, with
GTS 800” or “Baseline Option – Legacy – GTX 33 ES Installation”
(as applicable).
Press
ENT
key on the PFD.
7. Press the
CLR ALL
softkey.
8. Use the large FMS knob to scroll to GTX.
9. Highlight the software box(es) and press the
ENT
key to check the box.
10. Highlight the Configuration box and press the
ENT
key to check the box.
11.
Press “
Load
” softkey.
12. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green “PASS” in the Configuration and Software columns for each item loaded.
•
“Upload Complete………….”COMPLETE” in the summary box.
13. Acknowledge the prompt by pushing the
ENT
key.
14. Deactivate the cursor.
15. Scroll to the Configuration Manager page.
16. Press the
CNFM CFG
softkey.
17.
Select ok when prompted to “Confirm configuration as expected configuration”
18. Power cycle the system verify there are no red-Xs or system alerts.
19. If red-Xs or system alerts are present, troubleshoot as necessary using Section 5.
20. If there are no red-Xs or system alerts, continue to Section 7.5.3.
Transponder Configuration
1. If not applied, apply power to the G1000 system and put all displays into config mode.
2. On the PFD, select the AIRCRAFT CONFIGURATION page.
3. For GTX 33 unit replacement only, press the Set GTX #1 softkey and acknowledge the
PFD prompt by pressing the ENT key. GTX 335R and 345R units automatically save
the registration number, no action is needed for these units.
4. After completing transponder configuration, deactivate the cursor.
Summary of Contents for G1000 NXi
Page 61: ......
