G1000 Supplemental Maintenance Manual
Page 3-27
Textron Nav III Series
Revision 3
190-02128-04
GDL 69 Software/Configuration Loading (if installed)
Follow this procedure to configure the GDL 69 Receiver. Do not follow the procedures in this
section if a GDL69 unit is not installed or if a GDL 69A SXM unit is installed.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select
“Baseline
Option
– Legacy – GDL 69 Installation”
and press the
ENT
key to select it.
Press the
CHK All
softkey.
In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the “CARD COPY” configuration check box. Press the
ENT
key to uncheck
the configuration check box.
Press the
Load
softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green “PASS” in the Configuration and Software columns for each item loaded.
•
“Upload Complete………….COMPLETE” in the summary box.
Press the
ENT
key to acknowledge the prompt that appears in the pop-up box.
Disable CO Guardian Configuration Loading (if CO Guardian not installed)
Follow this procedure to disable the CO Guardian (if a CO Guardian is not installed). Do not
follow the procedures in this section if the aircraft is equipped with a CO Guardian.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select
“Option –
Disable CO Guardian Installation
”
and press the
ENT
key to select it.
Press the
CHK All
softkey.
In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the “CARD COPY” configuration check box. Press the
ENT
key to uncheck
the configuration check box.
Press the
Load
softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green “PASS” in the Configuration and Software columns for each item loaded.
•
“Upload Complete………….COMPLETE” in the summary box.
Press the
ENT
key to acknowledge the prompt that appears in the pop-up box.
Summary of Contents for G1000 NXi
Page 61: ......
