Garmin G1000 NXi Cockpit Reference Guide for the da62
190-02622-00 Rev. A
appendix
175
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EIS
Nav/Com/
XP
d
R/
a
udio
Flight
Management
Hazar
d
avoidance
a
FCS
a
dditional
Featur
es
a
bnormal
o
per
ation
a
nnun/
a
lerts
a
ppendix
Index
aPPENdIX
daTaBaSE MaNaGEMENT
Database information is obtained from third party sources. Inaccuracies in the data may be
discovered from time to time. Garmin communicates this information by issuing a Database
Alert. These notifications are available on flygarmin.com.
Garmin requests the flight crew report any observed discrepancies related to da-
tabase information. These discrepancies could come in the form of an incor-
rect procedure; incorrectly identified terrain, obstacles and fixes; or any other dis-
played item used for navigation or communication in the air or on the ground.
Go to flygarmin.com and select Aviation Data Error Report.
Databases may be loaded through Garmin Pilot and the Wireless Transceiver. When loading
databases through Garmin Pilot and the Wireless Transceiver, the Wireless Transceiver must be
enabled on the system and the multimedia card inserted in the bottom SD slot of the MFD.
NoTE:
When loading database updates, the ‘DB Mismatch’ message will be displayed
until database synchronization is complete, followed by turning system power off,
then on. Synchronization can be monitored on the ‘Aux – Databases’ Page.
NoTE:
Loading a database in the system prior to its effective date will result in the
expiration date on the power-up screen and the effective date on the ‘Aux – Databases’
Page being displayed in amber.
LoadING UPdaTEd daTaBaSES
CaUTIoN:
Never disconnect power to the system when loading a database. Power
interruption during the database loading process could result in maintenance being
required to reboot the system.
All databases are updated through a single SD card in the bottom slot of the MFD. When the
card is inserted, the databases on the card will be copied to standby and synchronized across
all powered, configured units. When in standby, databases are not immediately available for
use, but stored to be activated at a later time.
The cycles and dates for both standby and active databases are displayed on the ‘Aux –
Databases’ Page on the MFD. Any active databases with expiration dates in the past will be
highlighted with amber text. When an expired active database has a standby database that is
ready to become effective, a cyan double-sided arrow will be displayed between the database
cycles. When this arrow is visible, it indicates that the standby and active databases in that row
Summary of Contents for G1000 NXi
Page 1: ...Cockpit Reference Guide Diamond DA62 System Software Version 2056 10 or later...
Page 2: ......
Page 4: ......
Page 219: ......
