190-00692-00 Rev. B
Garmin G1000 Pilot’s Guide for Piper PA32
4-29
AUDIO PANEL AND CNS
Entering a transponder code with the PFD FMS Knob:
1)
Press the
XPDR
and the
CODE
Softkeys as in the previous procedure to enable code entry.
2)
Turn the small
FMS
Knob on the PFD to enter the first two code digits.
3)
Turn the large
FMS
Knob to move the cursor to the next code field.
4)
Enter the last two code digits with the small
FMS
Knob.
5)
Press the
ENT
Key to complete code digit entry.
Pressing the
CLR
Key or small
FMS
Knob before code entry is complete cancels code entry and restores the
previous code. Waiting for 45 seconds after code entry is finished activates the code automatically.
Figure 4-37 Entering a Code with the FMS Knob
Press the
ENT
Key to
Complete
Code Entry
Turn the Large
FMS
Knob
to Move the
Cursor to the
Next Code Field
Turn the Small
FMS
Knob to
Enter Two Code
Digits at a Time
VFR CODE
The VFR code can be entered either manually or by pressing the
XPDR
Softkey, then the
VFR
Softkey.
When the
VFR
Softkey is pressed, the pre-programmed VFR code is automatically displayed in the code field
of the Transponder Data Box. Pressing the
VFR
Softkey again restores the previous identification code.
The pre-programmed VFR Code is set at the factory to 1200. If a VFR code change is required, contact a
Garmin-authorized service center for configuration.
Figure 4-38 VFR Code
VFR Code
Summary of Contents for G1000:Piper
