190-00709-00 Rev. A
Garmin G1000 Pilot’s Guide for the Socata TBM 850
4-30
AUDIO PANEL AND CNS
Figure 4-35 Transponder Softkeys (PFD)
Selecting the
BACK
Softkey
returns to the top-level softkeys.
Selecting the
BACK
Softkey returns to the mode selection softkeys.
MSG
MSG
BACK
BKSP
IDENT
7
6
5
4
3
2
1
0
STBY
ON
ALT
VFR
CODE
IDENT
BACK
XPDR
GND
IDENT
XPDR1
XPDR2
Selecting and activating Transponder 1 or Transponder 2:
1)
Select the
XPDR
Softkey to display the Transponder Mode Selection Softkeys.
2)
Select the
XPDR1
or
XPDR2
Softkey to select and activate the other transponder.
When turning on the G1000 for use, the system activates Transponder 1 as the default unit, regardless of
which transponder was active prior to shutdown. When switching between Transponder 1 and Transponder 2,
the code and mode remain the same. If a new code is entered in the active transponder, switching transponders
does not bring back the previous code.
TRANSPONDER MODE SELECTION
Mode selection can be automatic (Ground and Altitude Modes) or manual (Standby, ON, and Altitude Modes).
The
STBY
,
ON
,
and
ALT
Softkeys can be accessed by selecting the
XPDR
Softkey.
Selecting a transponder mode:
1)
Select the
XPDR
Softkey to display the Transponder Mode Selection Softkeys.
2)
Select the desired softkey to activate the transponder mode.
