Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-00 Rev. A
358
HAZARD AVOIDANCE
SYSTEM TEST
NOTE:
Traffic surveillance is not available during the system test. Use caution when performing a system
test during flight.
The traffic system provides a system test mode to verify the system is operating normally. The test takes ten
seconds to complete. When the system test is initiated, a test pattern of traffic symbols is displayed on the
Traffic Map Page (Figure 6-94). The aural message
“TAS System Test Passed”
or
“TAS System Test Failed”
is
issued when the test is complete, and the traffic system will be in Standby Mode.
Testing the traffic system:
1)
Turn the large
FMS
Knob to select the Map Page Group.
2)
Turn the small
FMS
Knob to select the Traffic Map Page.
3)
Turn the
Range
knob to set the range to 2/6 nm to allow for the full test pattern to be displayed.
4)
Select the
TEST
Softkey.
Or:
1)
Press the
MENU
Key and turn the small
FMS
knob
to select ‘Test Mode’.
2)
Press the
ENT
Key.
TA at 9 o’clock,
Distance 2.0
nm, 200’ Below,
Climbing
Non-Threat
Traffic at
11 o’clock,
Distance 3.6
nm, 1000’
Above, Level
Proximity
Traffic at
1 o’clock,
Distance
3.6 nm,
1000’ Below,
Descending
Operating
Mode
Test Mode
Annunciation
Figure 6-94 System Test in Progress with Test Pattern
Summary of Contents for G1000H
