Maintenance Manual
190-02472-02
G3X Touch EFIS Part 23 AML STC
Revision 2
Page 96
6. Verify that the Traffic Status is in Standby mode. (i.e., TAS should not be displayed).
7. Attempt to place the system in Operate mode, if the aircraft is within TIS-A coverage, the system
will display Operate, if the aircraft is not within TIS-A coverage, the unit will display ‘Unavailable’.
8.7 WX-500 Stormscope Interface Check
1. Verify the GDU is in normal mode. For a dual GDU installation verify both are in normal mode.
2. Allow up to five minutes for the system to obtain a GPS position fix.
NOTE
If no other weather source is configured, the Stormscope button will be present instead of the Weather
button.
3. On the MFD, select the Weather button and then select the Stormscope Button.
4. Verify there are no warnings displayed.
5. On one MFD, press Menu.
6. Toggle between Cell and Strike modes and verify that the corresponding mode is displayed in the
bottom right corner of the MFD.
7. Toggle between 360° and Arc views and verify the image switches between a 360° view
surrounding the aircraft icon to an arc placed in front of the aircraft icon.
8.8 FIS-B Weather via ADS-B In
NOTE
The following steps may be performed as a ground check as long as the aircraft is within range of an FAA
ground station. If this is not the case, it is recommended that these checks be performed in flight within
range of an FAA ground station.
1. Verify the G3X Touch EFIS is in normal mode.
2. Verify the GPS and FIS-B source is in normal mode.
3. Allow up to five minutes for the system to obtain a GPS position fix.
4. On each installed GDU, select navigate to the Weather page, and press MENU then select the
FIS-B under the “Data Source” field.
5. Verify there are no warnings displayed.
6. Press MENU button and then select several FIS-B weather products to display.
7. Verify at least one of the selected products displays a valid time stamp.
8. Verify there are no status fail messages regarding FIS-B weather.
8.9 GDL 51R/52R SXM Weather Check
SiriusXM weather and radio activation is required for this check, reference Section 7.10 for instructions.
Position the aircraft where there is a clear view of the southeastern or southwestern sky. XM Satellite
Radio satellites are located above the equator over the eastern and western coasts of the continental
United States.
1. Verify the G3X Touch system is in normal mode.
2. Allow up to five minutes for the system to obtain a GPS position fix and the GDL 5XR to obtain
data.
3. On each GDU, select the Weather page from the multi-function pane.
4. Verify there are no warnings displayed.
5. Push the GDU knob to display weather data page.
NOTE
It may take up to 10 minutes after power-on for the system to begin receiving FIS-B weather products.
Summary of Contents for G3X Touch
Page 36: ......
