Maintenance Manual
190-02472-02
G3X Touch EFIS Part 23 AML STC
Revision 2
Page B-3
MFR
Model
Data
Format
G3X Configuration Setting
Interfacing Equipment
Configuration Setting
For dual GTN configure as
above (GTN 1) and below
(GTN 2):
(1)
Serial Port ‘x’:
“MapMX”
(
PFD or MFD)
for GTN 2
NOTE: “
x
” = Connected Port
# (GTN 1 must be connected
to a lower number port than
GTN 2. In dual GDU
installations GTN, #2 may be
connected to any port on the
MFD)
CHNL x Input/Output:
“Connext Format 2”
(When
Connext is used, #1 GTN Only)
NOTE: “
x
” = Connected Port
Main Indicator (Analog)
Config Page:
Selected Course for VLOC
:
“Ignored”
VOR/LOC/GS Config Page:
Nav Radio:
“Enabled”
ARINC 429 Config:
TX Speed:
“LOW”
SDI:
“VOR/ILS 1”
(“VOR/ILS 2”
for GTN 2)
Notes
:
(1) In installations with dual GTNs, GTN 1 must be connected to a lower number RS-232 port than
GTN 2. In dual GDU installations GTN, #2 may be connected to any port on the MFD)
(2) Only used when a Non-Garmin autopilot is interfaced, reference applicable interconnect diagrams
in the
G3X Touch EFIS AML STC Installation Manual
(190-02472-01).
Summary of Contents for G3X Touch
Page 36: ......