190-01115-01 G3X/G3X Touch Installation Manual - GDU 37X Config and Post Install Checkout
Rev. AC
Page 33-46
11. Go to the AP page in configuration mode and navigate to the Yaw Servo sub-section to configure
the servo direction.
a) The Servo Direction should be set to Normal. The servo arm should move clockwise to
cause a nose left rudder movement and servo arm should move counterclockwise to cause a
nose right rudder movement.
Figure 33-9 Normal Yaw Damper Direction
b) The Servo Direction should be set to Reverse. The servo arm should move clockwise to
cause a nose right rudder movement and the servo arm should move counterclockwise to
cause a nose left rudder movement.
Figure 33-10 Reversed Yaw Damper Direction
NOSE LEFT
NOSE RIGHT
NOSE LEFT
NOSE RIGHT