190-01115-01
G3X/G3X Touch Install Manual - GDU 4XX Config and Post Install Checkout
Rev. AC
Page 34-51
5. Go to the Main page in configuration mode and verify the CWS/DISCONNECT INPUT is
properly wired for each servo.
a) The CWS/DISCONNECT input should be LOW when the autopilot disconnect button is
pressed.
b) The CWS/DISCONNECT input should be OPEN when the autopilot disconnect button is
NOT pressed.
c) The system will compare the CWS/DISCONNECT INPUT from all servos, press and hold
the autopilot disconnect button for at least 5 seconds to verify there are no SYNC faults.