190-01115-01
G3X/G3X Touch Installation Manual - Connector Installation Instructions
Rev. AC
Page 24-4
24.3 Jackscrew Configuration Module Installation into a Jackscrew Backshell
Table 24-2 & Table 24-3 list parts needed to install a Jackscrew Configuration Module with pins or with
sockets. Parts for these installations are included in the 011-00979-20 and 011-00979-22 kits, which are
included in the G3X w/GSU 73 Installation Kit (K10-00017-00).
Configuration modules are to be installed in the backshells of the P732 connector for the GSU 73 (use
011-00979-20 in Table 24-2), the P3701 connector for GDU 37X designated as PFD1 (use 011-00979-22
in Table 24-3), or the P4X02 connector for the GDU 4XX designated as PFD1 (use 010-12553-00 in
Table 24-4)
Item numbers in Table 24-2, Table 24-3, and Table 24-4 correspond to
.
Table 24-2 GPN: 011-00979-20 – Kit (w/EEPROM and pins)
Item #
Description
Qty. Needed
GPN or MIL spec
1
Potted Module (w/EEPROM and
Temp.sensor)
1
011-02179-00
3
4 cond. Cable harness
1
325-00122-00
4
Pins Size 22D
4
336-00021-00
10
Pan head screw
1
211-60232-07
Table 24-3 GPN: 011-00979-22 – Kit (w/EEPROM and sockets)
Item #
Description
Qty. Needed
GPN or MIL spec
1
Potted Module (w/EEPROM and
Temp.sensor)
1
011-02179-00
3
4 cond. Cable harness
1
325-00122-00
9
Socket, Size 20, 26-30 AWG
4
336-00022-01
10
Pan head screw
1
211-60232-07
Table 24-4 GPN: 010-12253-00 – Config Module (w/EEPROM, Temp, & Connext)
Item #
Description
Qty. Needed
GPN or MIL spec
1
Config Module (w/Sockets,
Jackscrew, Temp, Connext)
1
011-03702-00
3
4 cond. Cable harness
1
325-00122-00
9
Socket, Size 20, 26-30 AWG
5
336-00022-01
10
Pan head screw
1
211-60232-07