4-52
Garmin G500H Pilot’s Guide
190-01150-02 Rev. J
For
ewor
d
Sec 1 System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazar
d
Avoidance
Sec 5
Additional Featur
es
Sec 6
Annun. & Alerts
Sec 7
Symbols
Sec 8
Glossary
Appendix A
Appendix B
Index
• Interference from buildings or mountains, which may cause shadows
• Metallic dust from military aircraft, which can cause alterations in radar
scans
4.7.6
XM Weather Page Map Orientation
The Orientation option sets the orientation of the Wx Data Link Map pages.
1) While viewing the Wx Data Link Map 1, 2, or 3 of the Wx page group, press the
MENU
key. With “Weather Setup” highlighted, press
ENT
.
2) Turn the small
MFD
knob to select “Weather Setup 1/2” and press
ENT
.
3) With the “Map Orientation” option active, turn the small
MFD
knob to change
the highlighted value.
Figure 4-34 Weather Page Map Orientation
4) Press
ENT
to accept the displayed value. The next option will be highlighted.
5) Press the small
MFD
knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large
MFD
knob to the next option.
4.7.7
NEXRAD Data Viewing Range
The NEXRAD Viewing Range option allows you to select the map range
where at and below the selected value NEXRAD weather products will be shown
on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected,
NEXRAD weather data will not be shown. For the value (such as 100 NM) that
is selected, NEXRAD data will be shown at the selected map ranges (such as 100
NM) and lower.
1) While viewing a WX Data Link Map page of the WX page group, press the
MENU
key to display the Page
Menu Options
. The cursor flashes on the
“Weather Setup” option. Press
ENT
.
2) Turn the small
MFD
knob to select “Weather Setup 1/2” and press
ENT
.
Summary of Contents for G500H
Page 1: ...G500H Pilot s Guide ...
Page 365: ......
