3-35
190-01150-02 Rev. J
Garmin G500H Pilot’s Guide
For
ewor
d
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazar
d
Avoidance
Sec 5
Additional
Featur
es
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary
Appendix A
Appendix B
Index
The following information is always synchronized between both GDU 620
units:
• Selected Altitude
• Selected Heading
• Selected Course
• Selected Vertical Speed
• Airspeed Bug Values
• Airspeed Color Band Values
• System Pressure Units
• System Temperature Units
The following information can be synchronized between GDU 620s, or
changed independently, depending on the Crossfill Synchronization Settings:
• Barometric Correction (default ON)
• Selected CDI (default OFF)
When Barometric Correction is synchronized, any changes to the Barometric
Setting on either GDU will change it on both GDUs.
When the CDI is synchronized, any changes to the selected CDI on either
GDU will change it on both GDUs. Either pilot can change the OBS course on
either GPS. If the pilot selects GPS1 on the CDI and GPS1 is in OBS mode, any
course changes will move the OBS on GPS1, GDU1, and GDU2 (if the copilot
has GPS1 displayed on the CDI). Similarly, if the pilot selects GPS2 on the CDI
and GPS2 is in OBS mode, any course changes will move the OBS on GPS2,
GDU1, and GDU2 (if the copilot has GPS2 displayed on the CDI).
AHRS 1 and ADC 1 will only be displayed on GDU1. AHRS2 and ADC2 will
only be displayed on GDU2.
The
CDI
soft key toggles between selection of GPS or VOR/LOC as the active
navigation source. In a single GDU 620 system, the GDU
CDI
soft key will
change the source in the connected navigator and making a source change in the
navigator will be reflected in the GDU 620. In a dual GDU 620 system, the
CDI
keys in the navigator are disabled.
Summary of Contents for G500H
Page 1: ...G500H Pilot s Guide ...
Page 365: ......