4-68
Garmin G500H Pilot’s Guide
190-01150-02 Rev. J
For
ewor
d
Sec 1 System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazar
d
Avoidance
Sec 5
Additional Featur
es
Sec 6
Annun. & Alerts
Sec 7
Symbols
Sec 8
Glossary
Appendix A
Appendix B
Index
A Stationary Front is a front with very little horizontal movement. The line
alternates with orange and blue sections which point in opposite directions to
symbolize little movement.
Figure 4-50 XM Weather - Stationary Front
An Occluded Front is where a cold front has overtaken and merged with a
warm front. The line alternates with the blue triangle and orange half moon sym-
bols on the same side of the line pointing in the direction the front is moving.
Figure 4-51 XM Weather - Occluded Front
Surface Data Viewing Range
The Surface Data Viewing Range option allows you to select the map range
where at and below that value Surface Data weather products will be shown on
the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected,
Surface Data will not be shown. Where a value (such as 150 NM) is selected,
Surface data will be shown at map ranges of the selected value (150 NM) and
lower.
1) While viewing Weather Setup 1/2 menu, turn the large
MFD
knob to highlight
the Surface Data Viewing Range value.
2) Turn the small
MFD
knob to highlight the desired value. Press
ENT
to accept
the displayed value. The next option will be highlighted.
3) Press the small
MFD
knob to cancel selection or to end editing and return to
the previously viewed page or turn the large
MFD
knob to the next option.
Forecast Time
The Forecast Time option allows you to select the forecast time when the Surface
and City Forecast weather products will appear on the selected MFD Wx
Data Link Map page (1, 2, or 3). Forecasts are available for intervals of
current, 12, 24, 36, and 48 hours. The interval is selected by pressing the
FCST TIME
soft key on the Wx Data Link Map page.
Summary of Contents for G500H
Page 1: ...G500H Pilot s Guide ...
Page 365: ......
