190-01717-B1
G500/G600 TXi Part 23 AML STC Maintenance Manual
Rev. 1
Page 5-38
Figure 5-23 Fuel Flow Transducer Installation
5.12.5 RPM
The TXi system can use the electrical signal generated by the primary magneto coils or “P-Lead” to
display RPM. When used, the Left and Right magneto P-Lead signals must both be connected to the GEA
110. Connection can be made at the magneto or the ignition switch.
To replace the P-Lead wire, remove the old section of wire and replace the entire wire and parallel resistors
in accordance with the P-Lead installation instructions contained in the G500/G600 TXi Part 23 AML STC
Installation Manual (P/N: 190-01717-B3).
5()$1
%2/7(1*,1(%/2&.(;,67,1*
5()$1&:$6+(5(;,67,1*
5()061187(;,67,1*
EKd^
ϭ
,K>^/E^W/E'dKDd,E'/E^K>d^͘
Ϯ
,K>^/E^W/E'dKDd,&h>&>KtdZE^hZ͘
47< ,7(0 3$57180%(5 '(6&5,37,21
%5$&.(7)8(/)/2:6(1625
1$6)3 :$6+(5)/$767((/&$'3/$7(',1&+7+,&.,'2'
06/
1876(/)/2&.,1*5('8&('+(;$*215('8&('+(,*+75,1*%$6(81-)%
$1
$'$37(5675$,*+73,3(7278%(1377281-)$
$1
%2/70$&+,1($,5&5$)781)$,1*5,3'5,//('6+$1.
)7)8(/)/2:75$16'8&(5(/(&7521,&6,17(51$7,21$/
