190-01717-B1
G500/G600 TXi Part 23 AML STC Maintenance Manual
Rev. 1
Page 5-46
Table 5-4
Advanced Airframe Specific Configuration Data – Arc Ranges
Arc Color
Description
POH/AFM
Section
Note
RED
(LOW SPEED)
Low speed
awareness
2-Limitations
If the aircraft has a defined white or
green arc, set the red arc to ON. Set the
Max value of the red arc to the lowest
value of the white or green arc (Vs0). A
red low-speed awareness arc will
appear below the lowest marked stall
speed.
If the aircraft does not have defined
white or green arc, set the red arc to
OFF, and enter the lowest stall speed in
the Stall Speed setting at the bottom of
the page.
WHITE
Full flap operational
range
2-Limitations
Set the Min value to the bottom of the
POH/AFM defined range.
If WHITE and GREEN arcs overlap, set
the Max value to the beginning of the
WHITE/GREEN arc.
If White and GREEN arcs do not
overlap, set the Max value to the top of
the POH/AFM or aircraft specification
defined range.
If a WHITE arc is not defined by the
AFM/POH or aircraft specifications, set
both the MIN and MAX values to the
aircraft stall speed in the landing
configuration (Vs0). This setting will not
display white arc but the system needs it
to characterize aircraft performance.
HALF WHITE
Standard
operational range
2-Limitations
If the HALF WHITE arc range is not
defined by the AFM/POH or aircraft
specification, set to OFF.
This may sometimes be called a “narrow
WHITE arc.”
WHITE/
GREEN
Overlap between
standard operational
and flaps
operational ranges
2-Limitations
If a WHITE/GREEN arc is not defined by
the AFM/POH or aircraft specification,
set to OFF.
If WHITE and GREEN arcs overlap,
configure to the range they overlap
within.