190-01717-B1
G500/G600 TXi Part 23 AML STC Maintenance Manual
Rev. 1
Page 5-12
5.3 EIS Annunciator
5.3.1
Removal
The EIS caution and warning annunciator can be removed using the following procedure:
1. Using an Aerospace Optics cap extraction tool (P/N 17-150), locate the two extraction slots
positioned on either side of the pushbutton cap.
2. Insert the tool into the extraction slots and pull the cap out from the module.
NOTE
The cap will rotate 90 degrees on two hinged slide retainer pins to allow access to the
module mounting screws.
3. Loosen the two small flat head module mounting screws located behind the pushbutton cap until
the module can be removed from the housing.
4. Insert an Aerospace Optics connector extraction tool (P/N 18-234) into the slots at the top and
bottom of the electrical connector.
5. Push to release the snap tabs in the switch housing and gently pull the connector out of the module.
Figure 5-7 EIS Caution and Warning Annunciator Installation
5()02817,1*6/((9(3$57
2)$1181&,$725
5()
3/8*48,&.&211(&79,9,681
5()$,5&5$)7,167580(17
3$1(/
57<3
3$1(/&87287
7<3,&$/
EKd^
/DE^/KE^Z/E/E,^hE>^^Kd,Zt/^^W/&/͘
ϭ͘
Ϯ
Z/E/ZdKEddt/d,EEhE/dKZDKhEd/E'^>sdd,<^/K&/E^dZhDEdWE>Dh^dWZWZ
&KZ>dZ/>KEdK,/s/ZdhZZEdZ^/^dE>^^d,EKZYh>dKϭϬD/>>/K,D^^D^hZdtE
EEhE/dKZKzE/ZZ&d/E^dZhDEdWE>t/d,KEEdKZ/^KEEd͘
47< ,7(0 3$57180%(5
'(6&5,37,21
%(:30
$1181&,$7259'&,1&$1'(6&(17&$87,21$1':$51,1*(1*,1(,1',&$7,21$(5263$&(237,&6
/('%0(:30
$1181&,$7259'&/('&$87,21$1':$51,1*(1*,1(,1',&$7,21$(5263$&(237,&6
