Page 3-2
GMA 1347D Installation Manual
Revision C
190-00303-21
Table 3-2. Recommended Crimp Tools
18-20 AWG
22-28 AWG
Manufacturer
Hand
Crimping Tool
Positioner
Insertion/
Extraction Tool
(Note 2)
Positioner
Insertion/
Extraction
Tool
Military P/N
M22520/2-01
N/A
M81969/1-04 M22520/2-09
M81969/1-04
Positronic 9507
9502-11 M81969/1-04 9502-3
M81969/1-04
ITT
Cannon 995-0001-584 N/A
N/A
995-0001-739 N/A
AMP
601966-1 N/A
91067-1
601966-6 91067-1
Daniels AFM8
K774 M81969/1-04
K42
M81969/1-04
Astro 615717 N/A M81969/1-04
615725 M81969/1-04
NOTES
1.
Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
2.
Extracting the #16, #18 and #20 contact requires that the expanded wire barrel be cut off from
the contact. It may also be necessary to push the pin out from the face of the connector when
using an extractor due to the absence of the wire. A new contact must be used when
reassembling the connector.
3.
For applications using 16 AWG wire, contact Garmin for information regarding connector
crimp positioner tooling.
3.5 Backshell
Assembly
The GMA 1347D connector kit includes two Garmin backshell assemblies. Garmin’s backshell
connectors give the installer the ability to quickly and easily terminate shield grounds at the backshell
housing using the G1000 Shield Block. To assemble the backshell connectors and grounding system,
refer to instructions provided in the Shield Block Installation Instructions (190-00313-09).
