Wiring and Connection Considerations
It may be necessary to drill 32 mm (1
1
/
4
in.) holes for routing the power and network cables.
• When routing multiple cables through the same hole, you must route the network cable before the power
cable.
• You must apply marine sealant to the hole after the cables are in place to ensure a waterproof seal.
If you must make the routing hole in a visible location, decorative cable grommets can be purchased from
Garmin or a Garmin dealer (optional).
• If needed, you can trim the grommet to enable you to route the power and network cables through the same
hole.
• The optional grommet does NOT provide a waterproof seal. You must apply marine sealant to the grommet
after the cables are in place to ensure a waterproof seal.
When installing the cables, you should observe these considerations.
• Cutting the Garmin Marine Network cable is not recommended, but a field install kit can be purchased from
Garmin or a Garmin dealer if you must cut the network cable.
• To ensure safety, appropriate tie-wraps, fasteners, and sealant should be used to secure the cable along the
route and through any bulkheads or the deck.
• You should not run cables near moving objects and high-heat sources, or through doorways and bilges.
• To avoid interference with other equipment, you should not run network and power cables parallel to other
cables, such as radio antenna lines or power cables. If this is not possible, the cables should be shielded
with metal conduit or a form of EMI shielding.
• You should install the power cable as close to the battery source as possible.
◦
If it is necessary to extend the power cable, you must use the appropriate wire gauge (
).
◦
Incorrectly extended runs of cable may cause the radar to malfunction due to insufficient power
transmission.
Connecting the Power Cable
WARNING
When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the
product specifications. In addition, connecting the power cable without the appropriate fuse in place voids the
product warranty.
1 Route the power cable from the device to the power source.
2 Connect the red wire to the positive (+) battery terminal, and connect the black wire to the negative (-)
battery terminal.
3 If you have not already done so, connect the power cable to the device by turning the locking ring clockwise.
Power Cable Extensions
Connecting the power cable directly to the battery is recommended. If it is necessary to extend the cable, the
appropriate gauge of wire must be used for the length of the extension.
Distance
Wire Gauge
2 m (6.5 ft.)
16 AWG (1.31 mm²)
4 m (13 ft.)
14 AWG (2.08 mm²)
6 m (19 ft.)
12 AWG (3.31 mm²)
4
