Post-Installation Configuration & Checkout
GNS 480 (CNX80) Installation Manual560-0982-01 Rev A
3-31
Figure 3-30 – GPS Information Start-up Screen
If the exact position is not known, the GNS 480 can determine its own initial position. If it is desired to
let the GNS 480 determine its own position, do not enter the position, time and date after the
CHG
smart
key is pressed. Instead, use the use the large, outer knob to select the Master GPS Reset item and set it to
‘Yes’ using the small, inner knob. Press the
MENU/ENTER
key to accept the changes, and then press
the
MENU/ENTER
key again to acknowledge the STOP! message.
NOTE
GPS acquisition may take up to 20 minutes after a Master GPS Reset is performed.
3.3.2.1.2 GPS Operation and Position
Check the GPS operation as follows:
1.
Turn on the GNS 480 and allow the unit to acquire a position. All other avionics should be turned
off for this part of the test.
2.
Check the position using the GPS Status page, which is shown in Figure 3-31. This page is accessed by
pressing the
FN
key twice, causing the
SYS
smart key to be displayed. The
SYS
smart key is then
pressed, followed by the
GPS
smart key, if necessary. The lat/long displayed on this page should agree
with a known reference position.
Summary of Contents for GNS 480
