To add waypoints to the active route (while on the Active Route page):
1. Make sure the cursor is not flashing. If it is, press
C
.
2. Rotate
K
to display the waypoint you would like to insert the new waypoint BEFORE.
3. Press
C
.
4. Rotate
O
to highlight the waypoint you would like to insert the new waypoint BEFORE.
5. Use
K
and
O
to enter the new waypoint identifier. Press
E
.
You will be prompted to accept the new waypoint with the Waypoint
Confirmation page. If you make a mistake entering the waypoint, or do not wish to
add the waypoint, press
\
; or press
E
to add the new waypoint.
To display the Route Catalog page:
1. Press
R
, and rotate
O
, if necessary.
The Route Catalog page displays the following information:
42
REFERENCE
Route Information
Section
3
Adding a waypoint to the active route.
Route Catalog page
Route number
Parallel track distance selection
(Route 0 only)
or
Comments (Routes 1-19)
Route action field
Origin/Destination
identifers
Route
length
You can create routes by either adding new
waypoints to the active route (if it is empty) as
shown on the right, or by editing any of the other
19 routes as described on page 44.
150man rev E 7/24/98 3:10 PM Page 42
