190-02207-A2
GPS 175/GNX 375/GNC 355 Part 23 AML STC Maintenance Manual
Rev. 3
Page 3-6
3.4.3 Setup
This section provides a brief overview of the pages that are accessed from the
Setup
page. To access the
Setup
page, touch the
Setup
key from the Configuration mode home page.
Figure 3-5 Setup Page
(GNX 375 shown, GPS 175 and GNC 355 similar)
3.4.3.1 Interfaces
The
Interfaced Equipment
page allows for the configuration of the various input and outputs that support
interfaces to the GPS 175/GNX 375/GNC 355.
3.4.3.1.1 ARINC 429
The
Interfaced Equipment - ARINC 429
page allows the configuration of data formats and speeds of
ARINC 429 inputs and outputs.
3.4.3.1.2 RS-232 (RS-422)
The
Interfaced Equipment - RS-232 / RS-422
page allows the configuration of data formats for serial
ports.
• Port 1 is capable of operating as an RS-232 port (or an RS-422 port on GNX 375).
• Ports 2 and 3 are capable of operating as an RS-232 port.
• Ports 4 and 5 are only capable of operating as an RS-232 port and are only available on GNX 375.
3.4.3.1.3 ADS-B Source (GPS 175 and GNC 355 Only)
The
ADS-B SRC
button allows the selection of an ADS-B source.
3.4.3.1.4 GDU
The
GDU
toggle button indicates whether or not a GDU is
Present
or
Not Present
in the installation.
3.4.3.1.5 GI 275
The
GI 275
toggle button indicates whether or not a GI 275 is
Present
or
Not Present
in the installation.
3.4.3.1.6 Cross-Side Navigator
The
Cross-Side Navigator
button allows the selection of a cross-side navigator.
