8 - VLOC RECEIVER
148
190-00356-00 Rev B
Auto-tuning / CDI Key
8. For precson approaches and some non-pre-
cson approaches, a remnder wndow wll
appear ndcatng that GPS gudance on such
approaches s strctly for montorng only—use
the VLOC recevers and external CDI (or HSI) for
prmary navgaton. To confirm ths remnder,
hghlght “Yes?” and press
ENT
.
CDI Key
The GNS 430W’s
CDI
key is used to couple the
GPS or VLOC receiver to the external CDI (or HSI).
When the external CDI (or HSI) is being driven by
the GPS receiver, “GPS” will appear at the bottom left
corner of the page, directly above the
CDI
key. When
the external CDI (or HSI) is being driven by the VLOC
receiver, “VLOC” will appear instead.
To couple the external CDI (or HSI) to the GPS
receiver or VLOC receiver, press the CDI key to
display “GPS” or “VLOC”, as desired.
NOTE:
The external CDI (or HSI) must be coupled
to the VLOC receiver for approaches which are
not approved for GPS. See the ILS example in the
Procedures section.
GNS 430W Only
Summary of Contents for GPS 400W
