GPS 500 Pilot’s Guide and Reference
1-13
SECTION 1
INTRODUCTION
190-00181-60 Rev. G
Displaying frequencies for a different
airport along the flight plan.
1) Press the small
right
knob to highlight the
airport identifier field.
2) Turn the small
right
knob to display the list of
airports within the flight plan (Figure 1-20).
Figure 1-20 Airport Window
3) Continue turning the small
right
knob to select
the desired airport and press the
ENT
Key.
IFR Procedures
Once the direct-to or flight plan is confirmed, the whole
range of instrument procedures is available. Departures
(SIDs), arrivals (STARs), non-precision and precision
approaches are stored within the
NavData card and are
available using the
PROC
(procedures) Key.
To display the
Procedures Page (Figure 1-21), press the
PROC
Key.
Figure 1-21 Procedures Page
The steps required to select and activate an approach,
departure, or arrival are identical. This introductory
section shows examples of the steps required to select an
approach, but keep in mind the same process also applies
to departures and arrivals.
Selecting an approach, departure, or
arrival:
1) Turn the large
right
knob to select the desired
option (‘Select Approach?’, ‘Select Arrival?’,
or ‘Select Departure?’) from the Procedures
Page.
2) Press the
ENT
Key to display a list of
available procedures for the arrival (when using
approaches or STARs) or departure (when using
SIDs) airport.
3) Turn the small
right
knob to select the desired
procedure and press the
ENT
Key.
Summary of Contents for GPS 500
